Institut für Nachhaltige Chemie und Umweltchemie (INUC)
Filtern
Schlagworte
- Pestizid (2) (entfernen)
Among all attenuation processes, biodegradation plays one of the most important role and is one of the most desirable processes in the environment. To assess biodegradation, a variety of biodegradation test procedures have been developed by several international organizations. OECD guidelines for ready biodegradability testing represent one of the most prominent group of internationally used screening biodegradation tests (series 301A-F). These tests are usually very simple in their designs and allow for the fast and cheap screening of biodegradability. However, because of their stringency, the test conditions are not close to simulating environmental conditions and may lead to unrealistic results. To overcome these limitations, OECD introduced simulation tests which are designed to investigate the behavior of chemicals in specified environmentally relevant compartments. Despite the fact that simulation tests give more insight into the fate of chemicals in the environment, they are not applied frequently as they are often tedious, time consuming and expensive. Consequently, there is a need to provide a new biodegradation testing method that would combine complex testing environment as in simulation tests, easiness in handling and good data repeatability as in screening biodegradation tests. Another challenge is an adaption of the existing biodegradation testing methods to new types of samples, i.e. mixtures of transformation products (TPs). The research on the presence of pharmaceuticals in the environment gained momentum in the 1990s; since then, it has been growing. Their presence in the environment is a wellestablished fact. A wide range of pharmaceuticals is continuously detected in many environmental compartments such as surface waters, soils, sediments, or ground waters. After pharmaceuticals reach the natural aquatic environment they may undergo a number of processes such as: photolysis (under direct sunlight), hydrolysis, oxidation and reduction reactions, sorption, biodegradation (by bacteria of fungi), and bioaccumulation. These processes, may cause their elimination from aquatic environment, if reaction is complete, or creation of new compounds i.e., transformation products (TPs). What is more, processes, like chlorination and advanced oxidation processes (AOPs), such as H2O2/UV, O3/UV, TiO2/UV, Fenton, and photo-Fenton, or UV treatment which might be applied in water or wastewater treatment, may also lead to the TPs introduction into aquatic environment. The research on the TPs brings many new challenges. From one side, there is a constant need for the the development of a sensitive and reliable analytical separation, detection, and structure elucidation methods. Additionally, there is a need for the preparation of appropriate assays for the investigation of properties of new compounds, especially those answering the question if TPs pose a higher risk to the aquatic ecosystems than their parent compounds. Among numerous groups of pharmaceuticals, two are of great importance: antibiotics since they might promote emergence and maintenance of antimicrobial resistance in the aquatic environment; and cytostatic drugs. Cytostatic drugs can exert carcinogenic, mutagenic and/or teratogenic effects in animals and humans. The challenges of biodegradation testing presented in this thesis, encompasses these different areas of interest and was divided into three objectives: 1) Identification of the knowledge gaps and data distribution of the two groups of pharmaceuticals antibiotics and cytostatic drugs (article I); 2) Increasing the knowledge on biodegradation of cytostatic drugs and their TPs (articles II, III, and IV) and 3) Establishment of a biodegradation test with closer to simulation tests conditions, that could be affordable and to support better understanding on processes in water sediment interface construction - screening water-sediment test. Further validation of the test with an insight into sorption and desorption processes (articles V and VI).
Durch die fortschreitende Intensivierung der landwirtschaftlich genutzten Flächen in Deutschland wird im Rahmen der Ertragsteigerung oftmals ein erhöhter Einsatz von Düngemitteln und Pestiziden beobachtet. Da bislang nur wenige Abstandsauflagen zu Saumbiotopen bei der Zulassung von Substanzen festlegt wurden und darüber hinaus durch Abdrift, vor allem in Hauptwindrichtung von Agrarflächen, eine ungewollte Applikation ausgebrachter Fungizide auf Waldsäume (hier: Nichtzielfläche) anzunehmen ist, kann eine Gefährdung von Nichtzielorganismen nicht ausgeschlossen werden. Durch einen zulässigen Einsatz von Fungiziden im Forst und in Baumschulen werden Bestände auch unmittelbar mit Pestiziden exponiert. Im Rahmen dieser Arbeit wurde die Symbiose zwischen Bäumen als Nichtzielpflanzen und Ektomykorrhiza-Pilzen (ECM) als Nichtzielorganismen unter Fungizid- und Herbizid-Exposition untersucht. Als Modellsubstanzen wurden sowohl Pestizide mit einer Zulassung für Forstwirtschaft und Baumschulen wie auch mit Ackerbauzulassung gewählt. Die Anwendungsbereiche werden durch Konzentrationsniveaus (100% bzw. 10% der empfohlen Aufwandmenge, AM) abgebildet. Buchen, welche eine intakte Symbiose mit Ektomykorrhiza aufweisen, sind besser an ihre Umwelt angepasst und verfügen über Standortvorteile aufgrund einer effektiveren Nährstoff- und Wasseraufnahme. Diese Symbiose reagiert sensibel auf anthropogene Störungen wie Pestizidanwendungen. Die Substanzen können dabei sowohl über eine direkte Wirkung auf die Mykorrhiza-Pilze, wie auch über eine indirekt schädigende Wirkung auf die Wirtspflanze, die Symbiose beeinflussen. Ziel der Arbeit war es zu untersuchen, ob und welche Auswirkungen auf den Endpunkt Myzelwachstum von Ektomykorrhiza Pilzen durch eine Exposition zu beobachten sind. Zur Gefährdungsabschätzung wurden gemessene Pestizidkonzentrationen (MEC) in Gewächshausversuchen bestimmt; ECx Werte aus Konzentrations-Wirkungskurven ermittelt und die daraus resultierenden ökotoxikologischen Kenngrößen QR (Quotient Ratio) und TER (Toxic Exposure Ratio) berechnet. Dazu wurden zunächst in vitro Hemmversuche unter definierten Laborbedingungen durchgeführt. Als Endpunkt wurde das Myzelwachstum von Ektomykorrhiza-Pilzen definiert und entsprechende Kenngrößen wie EC10, EC50 und EC90 Werte für verschiedene Pestizid- ECM Modelle ermittelt. Als Modellorganismen wurden Pisolithus arhizus, Hebeloma crustuliniforme, Lyophyllum sp. und Cenococcum geophilum eingesetzt. Als Pestizide wurden die Wirkstoffe Quinoxyfen, Boscalid, Tebuconazol, Azoxystrobin sowie die Formulierungen Orius, Collis und Basta untersucht. Ergänzend dazu wurden Expositionsversuche im Gewächshaus durchgeführt und die Konzentrationen und Verteilungen der Wirkstoffe Tebuconazol und Boscalid in den Kompartimenten Boden1, Wurzelnaher Boden2 und Wurzel bestimmt. Hierzu wurde eine Methode zur Aufbereitung, Extraktion und Analyse mittels LC- MSMS in den verschiedenen Kompartimenten entwickelt. Ebenfalls wurde eine Methode zur Messung der Substanz Tebuconazol im Myzel von Pisolithus arhizus entwickelt. Aufgrund der Ergebnisse konnte gezeigt werden, dass die Toleranz der Mykobionten auf eine Exposition von dem untersuchten Testorganismus und dem eingesetzten Wirkstoff sowie dessen Konzentration abhängt. Hierbei wurde für den sensibelsten Testorganismus im Versuch, Pisolithus arhizus, ein EC50 Wert kleiner 0,026 ng g-1 für eine Exposition mit Orius ermittelt. Für eine Exposition von Pisolithus arhizus mit dem Herbizid Basta wurde ein EC50 Wert von 0,4% AM entsprechend 6 g ha -1 Glufosinat berechnet. in dem für die Symbiose relevanten Kompartiment Wurzelnaher Boden Wirkstoffkonzentrationen im Bereich von 100 - 500 ng g-1 für Boscalid und 150 - 700 ng g-1 für Tebuconazol bestimmbar sind. in dem Kompartiment Wurzel sowohl der Wirkstoff Tebuconazol wie auch Boscalid nachgewiesen werden konnte. im exponierten Myzel von Pisolithus arhizus der Wirkstoff Tebuconazol nachgewiesen werden konnte. Es wird somit von einer Bioverfügbarkeit der Substanz Tebuconazol ausgegangen. aufgrund der Datenlage und einer Berücksichtigung eines TER-Wertes < 5, für nahezu alle Kombinationen ein erhöhtes ökotoxikologisches Risiko anzunehmen ist. Einzig für eine Exposition mit 10% AM Boscalid auf den Testorganismus Cenococcum geophilum konnte ein TER > 9 ermittelt werden. Somit erscheinen weitere Untersuchungen bezüglich der Auswirkung von Pestiziden auf die Nichtzielorganismengruppe Ektomykorrhiza sinnvoll und notwendig. Für die Bewertung muss ein geeignetes Testsystem für Bodenmikroorganismen wie Mykorrhiza-Pilze standardisiert und validiert werden. Die entwickelte und angewendete Plattenmethode als Standardmesssystem erscheint dafür geeignet. Im Rahmen der Pestizidzulassungen müssen in Zukunft möglicherweise Mykorrhiza-Symbiosen bedacht werden und Schutzmaßnahmen wie Anwendungsbeschränkungen oder Abstandsregelungen zu Saumbiotopen überdacht werden.